categorie

Coester - un fluido per iniezione bicomponente a base di silicati ed esteri Mautol 2K

fabbricante: Koester

categoria: KOESTER - prodotti chimici per l'edilizia

N. prodotto: 33931

Un multiplo del numero ordinato: 1 Aggiungi al carrello

Aggiungi agli Appunti Chiedi un prodotto Segnala un errore nella descrizione L'acquisto a rate è disponibile a partire da 100 PLN di valore del prodotto o dall'intero ordine.

prezzo su richiesta

prezzo di listino
unità netta
9.51EUR
per kg
prezzo promozionale
unità netta
7.94EUR
per kg
minimo commerciale
quantità del prodotto
39.50 kg
unità
commercio
39.50 kg
prezzo totale
listino prezzi netto
375.72EUR
per 39.50 kg
prezzo totale
rete promozionale
313.80EUR
per 39.50 kg
prezzo di listino
unità lorda
11.70EUR
per kg
prezzo promozionale
unità lorda
9.77EUR
per kg
minimo commerciale
quantità del prodotto
39.50 kg
unità
commercio
39.50 kg
prezzo totale
listino prezzi lordo
462.13EUR
per 39.50 kg
prezzo totale
promozionale lordo
385.97EUR
per 39.50 kg

Descrizione del prodotto

Initial, two-component fluid based on silicate and ester, used to make a horizontal diaphragm. This is to cut off capillary pull-up moisture. The product narrows the capillaries and has a hydrophobic effect. It can be used by low-pressure injection, also in walls with significant moisture. The preparation is characterized by a high content of active substances.

Properties

  • two-component injection fluid
  • low viscosity
  • based on silicate and ester w
  • shows the gelling effect of component B, thanks to which it can also be used in highly damp parts of the building without the need to dry them first
  • material effective even when the walls are moist with tendons up to 95% - has been tested according to the WTA 4-4-04 / D instructions
  • apart from restoring horizontal insulation, Koester Mautrol 2K increases the strength of concrete and masonry substrates and provides additional protection against the penetration of aggressive substances
  • does not cause corrosion of the reinforcement

Application

  • low-pressure injection performed to restore horizontal insulation against capillary-rise moisture in walls with moisture up to 95%
  • can be used in masonry or concrete walls, as well as to strengthen masonry walls made of natural stone or brick
  • inside and out
  • it can also be used only to increase the strength of the wall
  • for making horizontal diaphragms in walls against capillary rising moisture in accordance with the WTA 4-4-04 / D instruction, above the water damming level

Technical data

  • material base silicates / silicates esters
  • color milky white, transparent
  • density: component A 1.16 g / cm 3 ; component B 1.09 g / cm 3
  • density after mixing 1.15 g / cm 3
  • initial viscosity approx. 30 mPa s
  • open time approx. 30-60 min (depending on the temperature)
  • consumption about 0.12 kg / m per 1 cm of wall thickness
  • mixing ratio (by weight) A 100 parts: B 9 parts
  • mixing ratio (by volume) A 100 volume units: B 9.4 volume units

allegati