categorie

Eurotermika - Pannello in polistirene Super Podłoga 100-037

fabbricante: Eurotermika

categoria: EUROTERMIKA - polistirolo

N. prodotto: 22413

Un multiplo del numero ordinato: 1 Aggiungi al carrello

Aggiungi agli Appunti Chiedi un prodotto Segnala un errore nella descrizione L'acquisto a rate è disponibile a partire da 100 PLN di valore del prodotto o dall'intero ordine.

prezzo su richiesta

prezzo di listino
unità netta
76.09EUR
per m3
prezzo promozionale
unità netta
54.66EUR
per m3
minimo commerciale
quantità del prodotto
1.00 m3
unità
commercio
1.00 m3
prezzo totale
listino prezzi netto
76.09EUR
per 1.00 m3
prezzo totale
rete promozionale
54.66EUR
per 1.00 m3
prezzo di listino
unità lorda
93.60EUR
per m3
prezzo promozionale
unità lorda
67.24EUR
per m3
minimo commerciale
quantità del prodotto
1.00 m3
unità
commercio
1.00 m3
prezzo totale
listino prezzi lordo
93.60EUR
per 1.00 m3
prezzo totale
promozionale lordo
67.24EUR
per 1.00 m3

Descrizione del prodotto

Super Podłoga 100-038 polystyrene is intended for thermal insulation that transfers mechanical loads, not exceeding 3.0 t / m.
EPS Super Floor 100-037 is used as thermal insulation:

  • walls below ground level with waterproofing are normally loaded
  • plinth in the BSO system
  • floors in an underfloor heating system
  • flat roofs
  • floor under the floor screed, normally loaded
  • floor on the ground, normally loaded
  • flat roof with waterproofing
  • steep roof above, below and between the rafters
  • terrace in and balcony in
  • internal ceilings between heated and unheated rooms

Caution

Milled edges from 5 to 16 cm: an additional fee of PLN 5.00 / m. Information on the thickness and finish of the edges of the boards should be provided in the commentary to the order. Due to frequent price movements due to reasons beyond our control, please confirm the price each time you buy.


Dati tecnici - proprietà

classificazione al fuoco - reazione al fuoco:
E
coefficiente di conducibilità termica λ:
0,037 W / mK
deformazione in determinate condizioni di carico di compressione e temperatura:
<= 5 %
resistenza alla flessione:
≥ 150 kPa
sollecitazione di compressione al 10% di deformazione relativa:
≥ 100 kPa
stabilità dimensionale in condizioni normali di laboratorio costanti DS (N) 5:
± 0,5 %
stabilità dimensionale in determinate condizioni di temperatura e umidità DS (70, -) 2:
<= 2 %