categorie

Qmar - schiuma pistola a bassa pressione

fabbricante: Qmar

categoria: QMAR - prodotti chimici per l'edilizia

N. prodotto: 15543

Un multiplo del numero ordinato: 12 Aggiungi al carrello

Aggiungi agli Appunti Chiedi un prodotto Segnala un errore nella descrizione L'acquisto a rate è disponibile a partire da 100 PLN di valore del prodotto o dall'intero ordine.

prezzo su richiesta

prezzo di listino
unità netta
7.06EUR
per pezzi
prezzo promozionale
unità netta
6.61EUR
per pezzi
minimo commerciale
quantità del prodotto
1.00 pezzi
unità
commercio
1.00 pezzi
prezzo totale
listino prezzi netto
7.06EUR
per 1.00 pezzi
prezzo totale
rete promozionale
6.61EUR
per 1.00 pezzi
prezzo di listino
unità lorda
8.68EUR
per pezzi
prezzo promozionale
unità lorda
8.12EUR
per pezzi
minimo commerciale
quantità del prodotto
1.00 pezzi
unità
commercio
1.00 pezzi
prezzo totale
listino prezzi lordo
8.68EUR
per 1.00 pezzi
prezzo totale
promozionale lordo
8.12EUR
per 1.00 pezzi

Descrizione del prodotto

A product with excellent performance for professional use. For application via foam gun. Reduced expansion during binding - does not warp the frames. Recommended for PVC profiles.

Application

Strong and durable fixing of window and door frames. Filling cracks, crevices and fractures in the walls, supplementing thermal insulation.

properties

  • excellent adhesion to most materials used in construction,
  • skin formation time up to 15min,
  • setting time from 2 to 6 hours,
  • high efficiency - up to 45 L.

Method of use

  • Thoroughly clean and degrease the working substrate
  • Before use, make sure the can is positive (optimum +20 C).
  • Shake the can well (for about 30 seconds) to thoroughly mix the ingredient in.
  • Screw the gun to the can, the working position for assembly is the can position "to the top".
  • Apply foam from below to the gap.
  • Fill the joints up to 60% deep, but not more than 5 cm per one layer, wider than 5 cm should be filled in layers,
  • Moisten each layer after application with water, e.g. with a sprayer.
  • Excess foam after curing should be removed mechanically (e.g. with a knife).
  • After full hardening, the foam should be protected against UV rays using plaster, paints, for example.

Dati tecnici - proprietà

colore:
kremowy
densità apparente:
19 ± 10% kg / mc
efficienza (senza formazione di schiuma):
48 L
resistenza termica dopo l'indurimento:
od –60 do +100 ºC
tempo di impostazione:
2 - 24 h
colore:
kremowy
confezione [ml]:
750 ml
densità apparente:
19 ± 10% kg / mc
resistenza termica dopo l'indurimento:
od –60 do +100 ºC
temperatura di conservazione:
od +15 do +25 ° C

allegati