categorie

Weber - intonaco acrilico-silicone a strato sottile TD325

fabbricante: Weber - Maxit

categoria: WEBER - prodotti chimici per l'edilizia

N. prodotto: 24178

Un multiplo del numero ordinato: 1 Aggiungi al carrello

Aggiungi agli Appunti Chiedi un prodotto Segnala un errore nella descrizione L'acquisto a rate è disponibile a partire da 100 PLN di valore del prodotto o dall'intero ordine.

prezzo su richiesta

prezzo di listino
unità netta
84.52EUR
per pacchetto
prezzo promozionale
unità netta
53.76EUR
per pacchetto
minimo commerciale
quantità del prodotto
1.00 pacchetto
unità
commercio
1.00 pacchetto
prezzo totale
listino prezzi netto
84.52EUR
per 1.00 pacchetto
prezzo totale
rete promozionale
53.76EUR
per 1.00 pacchetto
prezzo di listino
unità lorda
103.96EUR
per pacchetto
prezzo promozionale
unità lorda
66.12EUR
per pacchetto
minimo commerciale
quantità del prodotto
1.00 pacchetto
unità
commercio
1.00 pacchetto
prezzo totale
listino prezzi lordo
103.96EUR
per 1.00 pacchetto
prezzo totale
promozionale lordo
66.12EUR
per 1.00 pacchetto

Descrizione del prodotto

Exterior wall protection, colored, interior and exterior wall finishing, finishing layer in the Weber SD010 comprehensive insulation system. Weber TD325 acrylic-silicone plaster can be laid on insulation systems based on insulation from foamed polystyrene boards, while the full cooperation of all elements in the system is obtained using Weber products listed in Technical Approval ITB AT 15-3062 / 2007. Weber TD325 can also be used on cement plasters and putty, cement-lime plasters, plasters and gypsum putty, plasters based on organic resins, concrete elements, a layer of putty glue with embedded reinforcing glass fabric. It is not recommended to apply the plaster on unprotected against precipitation, horizontal or inclined surfaces.

Technical data:
- plaster based on water dispersion of acrylic resin with the addition of silicone resin,
- in the form of a paste, ready to use,
- permanent
- resistant to exhaust gases and chemical air pollution,
- increased flexibility,
- possibility of application at low temperatures (after using the weber binding accelerator PC251),
- very low surface absorption,
- can be washed with water,
- very good adhesion to various substrates,
- ease of application,
- low sensitivity to atmospheric conditions during binding,
- volumetric weight: 1.6 - 1.8 g / cm3,
- setting time for plaster approximately 48 hours,
- adhesion> 0.2 N / mm,
- diffusion resistance coefficient μ = 110,
- open drying time: about 20 minutes,
- consumption (kg / m2)
"Lamb" 1.5 mm - 2.5 - 3.0
"Lamb" 2.0 mm - 3.5 - 4.0
"Bark beetle" 1.5 mm - 2.5 - 2.8
"Bark beetle" 2.0 mm - 2.8 - 3.0
- available in 248 colors according to the Weber Color Spectrum,
- packaging: 30 kg,
- quantity on the pallet 480 kg,
- the manufacturer has the required documents for use.