The ARCH-FLEX tape-angle is used for finishing all kinds of arches, circles and corners at any opening angle, e.g. around windows or doors. The tape straightens, straightens and stiffens complicated, difficult-to-lead external corners and internal corners of the walls and ceiling. ARCH-FLEX is used where the internal corners or external corners of the walls pass from straight lines into arches.

Advantages

• It has all the features of a traditional angle bar.
• It allows you to connect a corner in a straight line with arches.
• Extremely durable.
• Easy and quick to install.
• It has a unique structure that creates rigid and smooth surfaces.
• Provides straight corner lines in the inside and corner in the outside Resistant to water and rust.
• Efficient because it allows you to use 100% material.
• It does not require soaking in water.
• It allows you to cover any paint.
• It does not require the use of additional tools, such as paper clips or mounting tapes.
• Convenient to use, transport and store thanks to winding on a roll.

Method of use

1. Measure the entire surface exactly where you want to apply the angle tape.
2. Cut the ARCH-FLEX tape to the correct length, cut the end of the ends at an angle of 45 degrees, then fold it in half.
3. If you use ARCH-FLEX when moving from a straight edge to an arc, mark the transition point before installing and remove the outer strip at the transition point.
4. Install the angle bracket using gypsum mass at the destination.
5. Remove excess mass using a spatula and adjust to a smooth curve. A second mass coat can be used after the first one has dried.

Additional tips

1. Use gypsum in powdered. Mix them thoroughly with water.
2. Adjust the right amount of gypsum to ensure gluing and filling and free squeezing of excess mass.
3. In the case of a corner in the interior? bend the tape wider than the corner angle requires. This will make the tape stick better to the wall.
4. For corners in the outside? use the opposite method and bend the tape to a smaller angle.