A hydrophobic cream used to make a diaphragm in walls that interrupts the rising capillary moisture. It is pressed into a series of holes in the wall joint drilled with a conventional putty gun. No special equipment is required to perform the injection. The product diffuses in a damp wall, creating a diaphragm that prevents capillary water rising.

Features

• easy to use with little risk of error
• one-component material, ready to use
• quick to make - no need to drill holes twice, no pressure or use of gravity
• quick to manufacture, without waiting for material pumping, as is the case with pressure methods or tank refilling, as in gravity methods
• very little material loss
• without the need to pre-seal the surface around the injection holes, which is the case with pressure methods
• approximate, uniform consumption and easy calculation of the amount of material needed
• no special, expensive pumps are required
• almost complete elimination of leakage and dirt on the construction site; no problems related to leakage of injection at partition walls, at recesses
• low hazard, on the water thinner, non-alkaline, non-flammable
• a small amount of waste in
• without the risk of increased occurrence of efflorescence on the surface, which may occur when using silicone material
• formula with a high concentration of active ingredient (about 80%), introducing a smaller amount of passive ingredient into the wall, better results when compared to injections with a large amount of fillers

Application

The product can be used to make a diaphragm that prevents capillary rising of moisture in almost all types of masonry, i.e. brick walls, solid walls, cavity walls (double walls), stone walls and masonry walls with a stone core or similar.

Technical data

• chemical base silane based emulsion w
• white color
• density ~ 0.90 kg / dm ³ (at +20 C)
• ambient temperature at application from +5 C to +35 C; injection works should be performed when the expected wall temperature will not be lower than 0 C for at least 48 hours from the injection, which is to ensure proper diffusion of the material
• storage conditions: store the product in original, undamaged and sealed packaging, in a dry room at a temperature of +5 C to +35 C; protect from direct sunlight and moisture; The material is best used within 12 months from the production date
• 600 ml sausage pack and 300 ml cartridges

The theoretical consumption is shown in the table below. The actual consumption depends on the conditions on the construction site - it is recommended to assume 10% higher consumption than theoretical one.